job week: DIY Tuesday :: Fabric Covered Binder

One of my sweet friends asked for a Food Planning Binder from her hubby for Christmas - I gladly said I would make them one :) I didn't know how to go about making the actual "binder" part - I wanted it to be unique, but of course, still functional. I tried taking apart a binder and putting it back together with booktape and gluing fabric and such, but it was a fail. So next I decided to try and just glue the fabric to an actual binder (a used binder in great condition- yay for reusing!), and glue sturdy cardstock paper on the insides. It worked quite well and was a fairly easy project.

Not much is needed to make your own- an old binder that still has functional rings, some glue and cardstock paper.

Supplies:
+ Old binder that needs an update (I used a standard size that holds 8.5"x11" paper)
+ Fabric
+ Spray adhesive (I use 3M Super 77 - once you spray this stuff, it is SUPER permanent)
+ 2 sheets of 12"x12" cardstock that coordinate with your fabric
+ Rotary blade, metal ruler and cutting mat
Optional: Fabric glue and 4 butterfly clilps (to reinforce the corners once you glue the fabric to the binder)

Start by cutting the piece of fabric down so that it is about 1" larger than the binder on all sides.

Cut the corners off - this will make it easier when gluing.

Now comes the tricky part. Lay the fabric wrong side up on a large piece of paper or newspaper (or fabric) that you don't mind getting spray adhesive all over. I used an old remnant piece of upholstery fabric that I had no use for.

Spray the entire piece of fabric that you are adhering to the binder, taking care to get all the way to the edges (do be careful that your spray is even if you are using a lightweight fabric, as the glue can sometimes permanently make glue spots on the other side).

Carefully lay the binder in the center of the now-covered-in-glue-fabric, putting the spine part down first, and then each side. Pull up the top center and bottom center parts of fabric and carefully tuck them under the binder ring clasp (see picture below). Now work your way inch by inch pulling the fabric down over the edge of the binder.

I left the corners undone while I secured all of the edges-- then wrap the cut part of the corner onto the binder first and finish securing the sides on top of that (see picture below).

I decided to reinforce the corners to make sure they would stay put. I used a couple dabs of fabric glue and then put butterfly clips on to hold it for about 10 minutes.

Next, I cut down the 12"x12" cardstock sheets to approximately 9.5"x11.25" and rounded the corners - this allows for about .25" all the way around where the fabric is - so you can see about .25" of fabric on the inside. Be sure to measure the insides of your binder to make sure you are cutting down to the right size (the right side of the binder ended up needing about .25" more on one side because I glued the fabric a little off). Cover only up to the fold in the binder, otherwise it won't be able to shut properly (see one of the final close up photos below).

Spray with spray adhesive and secure to each of the insides of the binder.